Since we now use the short_channel_id to identify the next hop we need
to resolve the channel_id to the pubkey of the next hop. This is done
by calling out to `gossipd` and stuffing the necessary information
into `htlc_end` and recovering it from there once we receive a reply.
Mainly switching from the old include to the new include and adjusting
the actual size of the onion packet. It also moves `channel.c` to use
`struct hop_data`.
It introduces a dummy next hop in `channel.c` that will be replaced in
the next commit.
We now have two partially overlapping state-machines: the channel
state and the announcement state. We need to request signatures from
the HSM to exchange them with the peer, and we need to have both sets
of signatures before we can proceed and send the actual announcements.
We call channel_sent_commit *before* sending (so we know if we need
to), so the name is wrong. Similarly channel_sent_revoke_and_ack.
We can usefully have them tell is if there is outstanding work to do,
too.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Passing through 'struct peer *' was a layering violation.
Reported-by: Christian Decker <decker.christian@gmail.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The three cases we care about only happen on specific transitions:
1. They can no longer spend our failed HTLC: we can fail the source now.
2. They are fully committed to their new HTLC htlc: we can forward now.
3. They can no longer timeout their fulfilled HTLC: the funds are ours.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The direction bit was computed in several spots and was inconsistent
in some cases. Now we compute it just in routing, and once when
starting up `channeld`, this avoids recomputing it all over the place.
Before exiting, `channeld` constructs and sends a `channel_update`
marking the channel as disabled. This is the pro-active signalling
that the channel may no longer be used.
Use msg_enqueue's wake and msg_queue_wait, and don't clone packets since
msg_enqueue() respects take.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We remove the unused status_send_fd, and rename status_send_sync (it
should only be used for that case now).
We add a status_setup_async(), and wire things internally to use that
if it's set up: status_setup() is renamed status_setup_sync().
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This is a little more awkward, as we used to do some work
synchronously (the init message), but it's still pretty clear.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We have some duplication in handling queues, so this is an attempt at
deduplicating some of that work. `daemon_conn` now uses the
`msg_queue` and `channeld` was also migrated to `msg_queue`. At the
same time I made `msg_queue` create a copy of the messages or takes
over messages marked with `take()`. This should make cleaning up
messages easier.
Christian Decker
Rusty Russell