We have a lot of infrastructure to delay local channel_updates to
avoid spamming on each peer reconnect; we had to keep tracking of
pending ones though, in case we needed the very latest for sending an
error when failing an HTLC.
Instead, it's far simpler to set the local_disabled flag on a channel
when we disconnect, but only send a disabling channel_update if we
actually fail an HTLC.
Note: handle_channel_update() TAKES update (due to tal_arr_dup), but we
didn't use that before. Now we do, add annotation.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We trade channel_update before channel_announce makes the channel
public, and currently forget them when we finally get the
channel_announce. We should instead apply them, and not rely on
retransmission (which we remove in the next patch!).
This earlier channel_update means test_gossip_jsonrpc triggers too
early, so have that wait for node_announcement.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
It's simpler and more robust to just check that it's not yet announced
(the broadcast index will be 0).
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Incrementing version number means stores which were prior to the previous
commit will be removed, and refreshed. The simplest fix, if not the most
efficient.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
BOLT 7's been updated to split the flags field in `channel_update`
into two: `channel_flags` and `message_flags`. This changeset does the
minimal necessary to get to building with the new flags.
That matches the other CSV names (HSM was the first, so it was written
before the pattern emerged).
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We would never complete further ping commands if we had < responses
than pings. Oops.
Fixes: #1928
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
If we receive a channel_announce but not a channel_update, we store the announce
but don't put it in the broadcast map.
When we delete a channel, we check if the node_announcement broadcast
now preceeds all channel_announcements, and if so, we move it to the
end of the map. However, with a channel_announcement at index '0',
this test fails.
This is at least one potential cause of the node map getting out of order.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
These happen after we compact the store; every log I've seen of a
restart on a real node has a message about truncating the store,
because node_announcements predate channel_announcements.
I extracted one such case from testnet, and reduced it to test here.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
@renepickhardt: why is it actually lightningd.c with a d but hsm.c without d ?
And delete unused gossipd/gossip.h.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
1. Move the list to the start of `struct peer`: memleak walks the
list correctly this way.
2. Don't create tal parent loop daemon->conn->daemon.
The second one is silly anyway: we exit via master_gone when the master
conn is closed.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Lightning charge tests stopped working without a timeout, being unable
to find a route. The 15 second delay doesn't matter in real life, but
in these scenarios it does. This fixes it by making sure the channel
is usable immediately.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
As pointed out by @rustyrussell the capacity is now always defined, so we can
fold that into the construction of the channel itself.
Reported-by: Rusty Russell <@rustyrussell>
Signed-off-by: Christian Decker <@cdecker>
The `htlc_minimum_msat` parameter was ignored so far, and we'd be attempting to
pay and hitting a brick wall by doing so. This patch just skips channels that
are not eligible anyway.
We know the total channel capacity after checking for its existence on-chain, so
we can actually make use of that information to discard channels that don't have
a sufficient capacity anyway, reducing the number of failed attempts.
We were adding channels without their capacity, and eventually annotated them
when we exchanged `channel_update`s. This worked as long as we weren't
considering the channel capacity, but would result in local-only channels to be
unusable once we start checking.
'cursor < ser + max' isn't valid because we reduce 'max' as we go! Effectively
we'll stop once we're past halfway, which can only happen with ipv6 + a torv2
address.
Ths fix is one-line, but we rename 'max' to 'len' which makes its purpose
clearer.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
tal_count() is used where there's a type, even if it's char or u8, and
tal_bytelen() is going to replace tal_len() for clarity: it's only needed
where a pointer is void.
We shim tal_bytelen() for now.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We delay internally to reduce broadcastig route flap, but errors are
a special case: we want to send the latest, otherwise we might send an
old (non-disabled) update.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We used to just manually set ROUTING_FLAGS_DISABLED, but that means we
then suppressed the real channel_update because we thought it was a
duplicate!
So use a local flag: set it for the channel when the peer disconnects,
and clear it when channeld sends a local update.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
gossip_getnodes_entry was used by gossipd for reporting nodes, and for
reporting peers. But the local_features field is only available for peers,
and most other fields are only available from node_announcement.
Note that the connectd change actually means we get less information
about peers: gossipd used to do the node lookup for peers and include the
node_announcement information if it had it.
Since generate_wire.py can't create arrays-of-arrays, we add a 'struct
peer_features' to encapsulate the two feature arrays for each peer, and
for convenience we add it to lightningd/gossip_msg.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This patch guts gossipd of all peer-related functionality, and hands
all the peer-related requests to channeld instead.
gossipd now gets the final announcable addresses in its init msg, since
it doesn't handle socket binding any more.
lightningd now actually starts connectd, and activates it. The init
messages for both gossipd and connectd still contain redundant fields
which need cleaning up.
There are shims to handle the fact that connectd's wire messages are
still (mostly) gossipd messages.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
connectd has a dedicated fd to gossipd, so it can ask for a new gossip_fd
for a peer.
gossipd has a standalone routine to create a remote peer (this will
eventually be the only way gossipd creates a new peer).
For now lightningd creates a socketpair but doesn't run connectd, so
gossipd never sees any requests on this fd.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Store the two we care about as booleans. Once connectd is complete we won't
even have the feature bitmaps for peers.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We weren't waiting for gossipd to actually process the
dev_set_max_scids_encode_size message, so under Travis it sometimes
split the reply before processing that.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Rusty Russell
lisa neigut
conanoc
Christian Decker
practicalswift