The wire protocol uses this, in the assumption that we'll never see feerates
in excess of 4294967 satoshi per kiloweight.
So let's use that consistently internally as well.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
There were two bugs here. First, grind_feerate() needs to check the
actual range of feerates, not the same rate over and over! Secondly,
we need to grind the feerate for the HTLC-success tx, too.
These were masked by the fact that our tests always use the same feerate!
"Untested code is buggy code"
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We currently rely on a zero exit status. That's the only difference between
onchain finished handling and other per-peer daemons, so instead we should
have an explicit "done" message. This is both clearer, and allows us to
unify.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We re-use the value for reasonable_depth given by the master, and we
tell it when our timeout transactions reach that depth.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
When we sent out an HTLC-Timeout or HTLC-Success tx, we need to spend
it after the timeout so it's safely in our wallet.
We generalize the tx_type OUR_UNILATERAL_TO_US_RETURN_TO_WALLET to
OUR_DELAYED_RETURN_TO_WALLET, since we use it for HTLC transactions too.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
When we see an offered HTLC onchain, we need to use the preimage if we
know it. So we dump all the known HTLC preimages at startup, and send
new ones as we discover them.
This doesn't cover preimages we know because we're the final
recipient; that can happen if an HTLC hasn't been irrevocably
committed yet. We'll do that in a followup patch.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
For non-delayed HTLC success spends, we have a similar pattern ("<sig>
<preimage> <wscript>") so a we want to use the same function.
The other routines don't say "witness" in them, and should.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This change is really to allow us to have a --dev-fail-on-subdaemon-fail option
so we can handle failures from subdaemons generically.
It also neatens handling so we can have an explicit callback for "peer
did something wrong" (which matters if we want to close the channel in
that case).
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This was causing some compilation trouble on 32bit systems, see #256.
Reported-by: @shsmith
Signed-off-by: Christian Decker <decker.christian@gmail.com>
To avoid everything pulling in HTLCs stuff to the opening daemon, we
split the channel and commit_tx routines into initial_channel and
initial_commit_tx (no HTLC support) and move full HTLC supporting versions
into channeld.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Rusty Russell
Christian Decker