We now have two partially overlapping state-machines: the channel
state and the announcement state. We need to request signatures from
the HSM to exchange them with the peer, and we need to have both sets
of signatures before we can proceed and send the actual announcements.
We call channel_sent_commit *before* sending (so we know if we need
to), so the name is wrong. Similarly channel_sent_revoke_and_ack.
We can usefully have them tell is if there is outstanding work to do,
too.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Passing through 'struct peer *' was a layering violation.
Reported-by: Christian Decker <decker.christian@gmail.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The three cases we care about only happen on specific transitions:
1. They can no longer spend our failed HTLC: we can fail the source now.
2. They are fully committed to their new HTLC htlc: we can forward now.
3. They can no longer timeout their fulfilled HTLC: the funds are ours.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The direction bit was computed in several spots and was inconsistent
in some cases. Now we compute it just in routing, and once when
starting up `channeld`, this avoids recomputing it all over the place.
Before exiting, `channeld` constructs and sends a `channel_update`
marking the channel as disabled. This is the pro-active signalling
that the channel may no longer be used.
Use msg_enqueue's wake and msg_queue_wait, and don't clone packets since
msg_enqueue() respects take.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We remove the unused status_send_fd, and rename status_send_sync (it
should only be used for that case now).
We add a status_setup_async(), and wire things internally to use that
if it's set up: status_setup() is renamed status_setup_sync().
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This is a little more awkward, as we used to do some work
synchronously (the init message), but it's still pretty clear.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We use the fourth value (size) to determine the type, unless the fifth
value is suppled. That's silly: allow the fourth value to be a typename,
since that's the only reason we care about the size at all!
Unfortunately there are places in the spec where we use a raw fieldname
without '*1' for a length, so we have to distingish this from the
typename case.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We have some duplication in handling queues, so this is an attempt at
deduplicating some of that work. `daemon_conn` now uses the
`msg_queue` and `channeld` was also migrated to `msg_queue`. At the
same time I made `msg_queue` create a copy of the messages or takes
over messages marked with `take()`. This should make cleaning up
messages easier.
Rusty Russell
Christian Decker