The adaptive MPP test was showing an issue with always using a routehint, even
when it wasn't necessary: we would insist on routhing to the entrypoint of the
routehint, even through the actual destination. If a channel on that loop
would result being over capacity we'd slam below 0, and then increase again by
unapplying the route. The solution really is not to insist on routing through
a routehint, so we implement random skipping of routehints, and we rotate them
if we have multiples.
This PR includes the fix discussed on PR #3855. This fix was tested with the use case described inside the issue and worked.
Fixes: #3855
Changelog-None
The test had part 1 and 2 backward, but still worked. When I copied that to
*after* the test had succeeded, it complained. It should always complain,
to catch bugs.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This wasn't important before, but now we have MPP it's good to enforce.
Reported-by: Christian Decker
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This exercises something that is simply not possible without MPP, i.e., the
bundling of multiple paths to get sufficient capacity to perform the payment.
Changelog-Added: The MPP presplit modifier splits large payments into 10k satoshi parts to maximize chances of performing the payment and to obfuscate the overall amount being sent.
As suggested during the paymod-03 review it is better to activate the new code
right away, and give users an escape hatch to use the legacy code instead. The
way I implemented it allows using either `legacypay` or `pay` and then set
`legacy` to switch to the other implementation.
Changelog-Added: JSON-RPC: The `pay` command now uses the new payment flow, the new `legacypay` command can be used to issue payment with the legacy code if required.
Suggested-by: Rusty Russell <@rustyrussell>
Suggested-by: ZmnSCPxj <@zmnscpxj>
This makes use of the payment modifier structure to just add the preimage to
the TLV payload for the last hop.
Changelog-Added: JSON-RPC: The `keysend` command allows sending to a node without requiring an invoice first.
This commit collects the changes required to the tests caused by the changes
to the `pay` and `paystatus` commands. They are also rather good hints as to
what these changes entail.
Make sure we've actually confirmed the HTLC; if it's not confirmed yet
then we won't fast-fail it, and we'll timeout instead:
```
> l1.rpc.waitsendpay(payment_hash=inv['payment_hash'], timeout=TIMEOUT, partid=1)
E AssertionError: Pattern 'WIRE_PERMANENT_CHANNEL_FAILURE \\(reply from remote\\)' not found in "RPC call failed: method: waitsendpay, payload: {'payment_hash': 'c186643391469aa8190415496c85b1eb789cb2b756a76d4c9ce21dd34c698d92', 'timeout': 30, 'partid': 1}, error: {'code': 200, 'message': 'Timed out while waiting'}"
```
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The status of what started as a simple JSON-RPC call is now spread across an
entire tree of partial payments and payment attempts. So we collect the status
in a single struct in order to report back success of failure.
This commit can be reverted/skipped once we have implemented all the logic and
have feature parity with the normal `pay`. It's main purpose is to expose the
unfinished functionality to test it, without completely breaking the existing
`pay` command.
We've been seeing some Travis timeouts under VALGRIND, with the
10 second timeout here: use TIMEOUT as per standard.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
And the percentage of the initial amount, not the constently increasing
one !
Changelog-Fixed: pay: we now respect maxfeepercent, even for tiny amounts.
Signed-off-by: Antoine Poinsot <darosior@protonmail.com>
Previously we've used the term 'funder' to refer to the peer
paying the fees for a transaction; v2 of openchannel will make
this no longer true. Instead we rename this to 'opener', or the
peer sending the 'open_channel' message, since this will be universally
true in a dual-funding world.
The documentation was wrong, and I copied my mistake to `libplugin` where it
was then ignored instead of ORed into the node's featurebits. This fixes both.
We weren't actually waiting until l3 got the channel_update from l2,
so it might not be able to create the routehint.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
When route returns a result which is too expensive, we try to figure out which
hop is most expensive to exclude it for next time.
If it's a single-hop route, we don't count it, since the first hop is free.
That's not usually a problem, since single-hop routes can't exceed our limits
(they're always "free"!).
But if we are using a routehint, the total cost could exceed our limits,
even if the start of the routehint is a single hop away.
This reproduces that test case.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This is what actually lets us pay blinded invoices.
Unfortunately, our internal logic assumes every hop in a path has a
next `short_channel_id`, so we have to use a dummy. This is
sufficient for testing, however.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Sending update_fee immediately after channel establishment seems to
upset LND, so work around it by deferring it. The reason we increase
the fee after establishment is because now we might need to close the
channel in a hurry due to htlcs, but until there are htlcs that's
unnecessary.
Fixes: #3596
Changelog-Changed: Added workaround for lnd rejecting our commitment_signed when we send an update_fee after channel confirmed.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The spec states that invoices with an amount, but lacking a multiplier, should
be interpreted as integer Bitcoin amounts:
`amount`: optional number in that currency, followed by an optional
`multiplier` letter. The unit encoded here is the 'social' convention of a
payment unit -- in the case of Bitcoin the unit is 'bitcoin' NOT satoshis.
Suggested-by: Stefano Pellegrini <@St333p>
Signed-off-by: Christian Decker <@cdecker>
Changelog-Fixed: invoice: The invoice parser assumed that an amount without a multiplier was denominated in msatoshi instead of bitcoins.
A CONSERVATIVE/3 target for them.
Some noisy changes to the tests as we had to update the estimatesmartfee
mock.
Changelog-Changed: We now use a higher feerate for resolving onchain HTLCs and for penalty transactions
We are returning a `BADONION` error despite the cause being an invalid onion
payload containing an unknown even TLV type. It really should return
`INVALID_ONION_PAYLOAD` errors instead.
Christian Decker
Vincent
ZmnSCPxj jxPCSnmZ
Rusty Russell
Antoine Poinsot
lisa neigut
Michael Schmoock